Choose “ ON” or “ OFF” to activate or deactivate the function. when starting the engine based on the position of the lighting stalk įrom the multifunction screen, select menu “vehicle”, “User settings” then “External welcome”. approximately one minute after lighting up Once the function is activated, the daytime running lights and the rear side light light up automatically upon detecting the RENAULT card or when the vehicle is unlocked. To switch off the lights before they go out automatically, turn ring 3 to any position, then return it to the AUTO position. The message “Follow-me home for _ _ _” along with the time the lights will be on for is displayed on the instrument panel to confirm this action. To increase this duration, you may pull the stalk up to four times (total time restricted to approximately two minutes). With the engine and lights switched off and the ring 3 in position 0 or AUTO, pull the stalk 1 towards you: the dipped beam headlights come on for approximately 30 seconds. This function allows you to briefly switch on the dipped beam headlights (to provide light when opening a gate, etc.). In this case, the next time the engine is started the lights will be switched back on according to the position of the ring 3.Ī warning beep sounds when the driver’s door is opened to warn you that the lights are still on. automatically, the lights will go out when the engine is switched off, the driver’s door is opened or the vehicle is locked. When the message “Check lighting” with warning light © is displayed and warning light k flashes on the instrument panel, this indicates that there is a lighting fault. The daytime running lights come on automatically with no action on stalk 1 when the engine is started, and they go off once the engine is switched off.
When the message “Check auto lighting” appears on the instrument panel, the system is deactivated. If any of the above conditions are not fulfilled, the system switches to dipped beam headlights. the vehicle speed is above approximately 25 mph (40 km/h). no other vehicles or lighting are detected The main beam headlights come on automatically if: It uses a camera located behind the interior rear-view mirror to detect vehicles that are being followed and those coming in the opposite direction. Turn ring 3 until the AUTO symbol is opposite mark 2: with the engine running, the dipped beam headlights switch on or off automatically depending on the brightness of the light outside, without any action on stalk 1.ĭepending on the vehicle, this system switches the main beam headlights on and off automatically. To return to the dipped headlight position, pull the stalk 1 towards you again. This indicator light on the instrument panel comes on. With the dipped beam headlights lit, push stalk 1. Turn ring 3 until the symbol is opposite mark 2.
0 kommentar(er)
